Leaderboard

roof rack installed ???

Okay, the replacement part/parts is "Rubber Stop", and I bought two. $15.25 each. 46512-H0101 Looks like they're both for the brake and cruise control. Also, maybe this is why my cruise control hasn't been working??? lol will check!

Man that is looking real nice, no messin' around there!

Finally got my diff back from the shop all new bearings and races, also the speed sleeve was worn. I installed most of it today just working on my old backing plates, since they are impossible to find, plus I can never justify the shipping. Lots of patience and looking back in my photos. I also re loomed the speedo cable with some braided stuff. Next project is doing the braided loom to the entire engine harness, lots of connections and fun! Sent from my iPhone using Tapatalk

Thanks for the replies everyone - I'm going to see about removing the inside panel per R50JR's instructions above. I have the service manual referrerd to and found the diagram on BT-17 (thanks Slartibartfast). I'll post up the results.

Sent from my iPhone using Tapatalk

Coastal Offroad. I like it better than the ARB but it has its issues too. I wish it had slightly more lip up front to more cleanly mount driving lights. The winch tray drains poorly & I’ve drilled my own drain holes. I wish the connections to the unibody were a little more extensive. All that said, I like it.

These dipsticks suck. One thing I’ve done to remove doubt is put a bubble level on my running board and use a jack and wheel choks to set the vehicle level in my driveway since it has some rake. Then I do my readings. I’ve ran overfilled by a quart for a year without issues. I’ve driven a week about quart low with no issues so adjusting fluid levels may not help any issues

and have the engine running, while

Drove 10 hours straight trim VA to hike up Mt.Washington and drive up the Auto Road. Old Blue didn’t skip a beat! Sent from my iPhone using Tapatalk

If you were close I'd sell you the 4.63 disc rear end out of my parts truck. It even had new pads/rotors/calipers shortly before I parked it!

Technically yesterday but installed my locker finally. Nobody told me how heavy this thing was gonna be [emoji23] In the process though I found that one brake cable is stuck in the backing plate and my driver side hard line twisted off Sent from my SM-G965U using Tapatalk

Hello everyone, the lock down has allowed to do surprising thing... I had my old pathy was parked for too long and this is what I have done so far.