Jump to content

johann_peralta

Members
 View Profile  See their activity

  • Posts

    302

  • Joined

  • Last visited

  • Days Won

    14

 Content Type 

Everything posted by johann_peralta

  1. johann_peralta
    Also finished up the winch bumper
  2. johann_peralta
    Took a while, but finally found some leafs that match the detentions i was looking for.
  3. johann_peralta
  4. johann_peralta
    Dude who was selling the Tons bailed, so im gonna set up the axle that was under it before. Cleaned it up for leafs
  5. johann_peralta
    right! He's either oblivious, or doesn't care!
  6. johann_peralta
    Stripped it back down and getting ready for tons
  7. johann_peralta
    Bringing this back to light because i'm gonna redo the suspension on this car. Going to drop it down to around 4-6" lift and 31s-35s. Learned a lot from the last build and now want to make this thing better.
  8. johann_peralta
    That being said, none of the lifts offered on sfcretions (https://sfcreation.com/t/pathfinder-1996-2004-r50-platform) require modifying the steering link.
  9. johann_peralta
    IF, all 3 pieces fit with a 1" SFD, its the same exact part numbers. Just a shorter shaft. Keyword: IF
  10. johann_peralta
    I can make you a 4" SFD kit (6 subframe blocks and 2 strut spacers)
  11. johann_peralta
    If you want a 4" sfd kit (2 strut spacers and 6 subframe blocks) DM me. I still make them by request.
  12. johann_peralta
    I just recently posted my spec sheet for a sfd kit
  13. johann_peralta
    100% legal luckily. Florida is way more lenient, than other crappy states like Crapifornia.
  14. johann_peralta
    Made a temp track bar (made it drive so much better). Wont be making a new one until I get a tube bender.
  15. johann_peralta
  16. johann_peralta
    The balljoints were previously shot, so we replaced them.
  17. johann_peralta
    Took Patricia out to the local lake
  18. johann_peralta
    Hard to explain using words only, but here goes my attempt. If you were to stack the 2 face plates on top of each other (with the long end facing away from you). The slope would go from the long end of the bottom one to the bolt opposite of the long end of the top one. Using that picture, the angle would go from the blue line of the bottom plate, to the hole touching the two red lines of the top plate. Using the picture, the strut spacer angles directly toward you.
  19. johann_peralta
  20. johann_peralta
  21. johann_peralta
  22. johann_peralta
  23. johann_peralta
  24. johann_peralta
    Here are the dimensions that I've used to make SFD kits. Have sold at least 15 so far, no problems yet.
  25. johann_peralta
×
×
  • Create New...