-
Posts
302 -
Joined
-
Last visited
-
Days Won
14
Content Type
Profiles
Forums
Calendar
Everything posted by johann_peralta
-
Also finished up the winch bumper
-
Took a while, but finally found some leafs that match the detentions i was looking for.
-
Dude who was selling the Tons bailed, so im gonna set up the axle that was under it before. Cleaned it up for leafs
-
right! He's either oblivious, or doesn't care!
-
Stripped it back down and getting ready for tons
-
Bringing this back to light because i'm gonna redo the suspension on this car. Going to drop it down to around 4-6" lift and 31s-35s. Learned a lot from the last build and now want to make this thing better.
-
That being said, none of the lifts offered on sfcretions (https://sfcreation.com/t/pathfinder-1996-2004-r50-platform) require modifying the steering link.
-
IF, all 3 pieces fit with a 1" SFD, its the same exact part numbers. Just a shorter shaft. Keyword: IF
-
I can make you a 4" SFD kit (6 subframe blocks and 2 strut spacers)
-
If you want a 4" sfd kit (2 strut spacers and 6 subframe blocks) DM me. I still make them by request.
- 10 replies
-
- 2
-
- r50
- pathfinder
-
(and 4 more)
Tagged with:
-
I just recently posted my spec sheet for a sfd kit
-
100% legal luckily. Florida is way more lenient, than other crappy states like Crapifornia.
- 83 replies
-
- 2
-
Made a temp track bar (made it drive so much better). Wont be making a new one until I get a tube bender.
- 83 replies
-
- 83 replies
-
The balljoints were previously shot, so we replaced them.
- 83 replies
-
Took Patricia out to the local lake
-
Hard to explain using words only, but here goes my attempt. If you were to stack the 2 face plates on top of each other (with the long end facing away from you). The slope would go from the long end of the bottom one to the bolt opposite of the long end of the top one. Using that picture, the angle would go from the blue line of the bottom plate, to the hole touching the two red lines of the top plate. Using the picture, the strut spacer angles directly toward you.
-
-
-
-
-
-
Here are the dimensions that I've used to make SFD kits. Have sold at least 15 so far, no problems yet.
-
- 83 replies