TooQForYou

I'm so glad I have a timing chain lol

Here's my results after installing 4x4design 1.5" front and rear spacers: Tires are 255/70-17 (31") Nitto Terra Grapplers Before (with OME 0.5" suspension lift) After 1.5" spacers front and rear:

Got the spacers installed. Haven't had any CV problems yet. I haven't tested the 4wd yet so I can't comment on that.

Uh oh... I have the OME springs front and rear, and just got the 1.5" spacers in the mail. I hope that half inch difference spares me this problem

There used to be camel4x4 but it seems that site no longer exists

Tirerack is having a $60 rebate card deal on Goodyears

Yeah 32" definitely won't fit without a lot of trimming. I just got 31" tires, 255/70-17 Nitto Terra Grapplers. They fill up the wheel well nicely I think. There is VERY minor rubbing on the front plastic wheel well liner when the wheels are fully turned. But then again I have an 01 qx4 so I don't know if there's any difference in the wheel well. I also took off my running boards and mud flaps. I also have some cheap 1" rubber coil spacers wedged up in there too. So there's a lot of different factors to consider here.

Ironman is cheaper.

If the weather cooperates, the ideal way to go would be AC off, windows up, fan on.

Nice!

VIP... psh.

I'm young, but beats me.

Holy crap that's a huge air vent! Oh, and congrats btw! Good looking car.

You probably don't know how lucky you are, but that front bumper sir is very rare. Also, backspace is only of concern if you want to run taller and wider tires, in which case having the proper backspace will prevent the tires from coming in contact with the struts.

That's a waste of an R50

Jackstand

Just blew another 20amp fuse. WTF?! EDIT: I think I'm shorting out somewhere between the fuse and the relay. I'll take a look tomorrow and report back.

I replaced the fuse and flipped the lights on and all works. This is through a relay with a dedicated inline fuse.

Well I had used them a few times without problem. Then the other day they just wouldn't come on, so I guess it happened when I flipped the switch.

I have two Hella 550s (55w) hooked up to my R50. According to calculations, 110w on a 12 volt system would be 9.16 amps. But I just blew a 20amp fuse. What's going on here?

You're mean.

You can also get lift springs from Ironman suspension.

Does the bar decrease ground clearance?

..and/or drinking? Very nice!