Leaderboard

Recently i bought an r50 to replace my wd21 after almost a year of chasing issues only for a new oil pump to fail. So far my r50 build has 31x*10.5r15 cooper adventurer A/T 15 inch lego wheels rockford fosegate p3 10" sony single din radio front rockford 6.5" speakers starlight headliner and blacked out headliner swapped out to some wood grain trim floor lights rear traffic adviser bar/chase bar cb radio and pa system rear amber/white lights side 4 inch pods-niglight-install in progress front 36 inch bar-niglight-install in progress front amber/white pods-niglight sfcreations 2.5/3" lift-install in progress mile marker hubs-in progress jchl tow strap 20,000 break x-bull 13,000lbs synthetic rope winch custom pipe bumper with front skidplate i will add some more photos of the bumper and winch when i get a chance. link to the drive folder with pictures

Had a little fun over the holidays. Hope the New Year is going well for everyone. Oh and be careful out there lol.

I’m gonna say no, unless the lighting is somehow massively changing how your blue shows up in photo. This blue was pretty flat toned unlike a lot of the “sparkly” colors offered on R50’s.

Pretty close! The all-mode switch is in the OE spot. "2WD" controls my tire inflation/deflation setup, "AUTO" charges the system (for locker or quick-connect use), "4H" engages the rear locker, and "4LO" engages both lockers. I just put the full details on my TJM thread to not clutter your thread.

I often think about keeping a handful of marbles in my jacket pocket when I am out on my Harley, but I resist the urge!

Posting in case someone else runs into the same...I need to replace the spring insulators on each end of each coil, 55034+A. They're ~$27 each, need 8 of them (two per coil). Over $200 for a cheap piece of plastic/poly sleeve. Screw that! Went to Home Depot and I'm using some tubing instead and saving ~$220. I don't mind spending money where it is worth it, but cannot convince myself these insulators are worth it. Top is the old insulator (it's old, thin poly), OEM $27 each , clear is the tubing I'm going to use to manufacture 8 of these for $1.20 each.

Shakedown run Sent from my iPhone using Tapatalk

of the wekeend in 4x4 track!

New Method wheels and Warn hubs installed Sent from my iPhone using Tapatalk

Apologies in advance this is gonna be a big post, lots of photos to dump! Me and my buddy Vic in his lifted Taco from Sunday's wheelin' trip these first two are on the way up to the top these next few are us at the top of the little mountain chillin' for a bit ***** FAT ASS ALERT ***** Last but not least, post mud pit... Hollister Hills SVRA, California

Blurry screen cap Sent from my iPhone using Tapatalk

All your images are really inspiring ? Hit me up on Instagram @darthfinder

Had some fun with the truck this weekend!