jwmyers23

Under the rear pass. seat and the floor board were both rusted out. I don't have any pics of the fix yet.

Lets see your fixes rust around a body mount Rusted drivers side Rusted pass side How do I fix this?

After 2 weeks of working on rust she runs again. I have 1 little spot up near the body mount by the drivers door. Then I need to tighten up the gas tank and do a little rework to my bumper. Then it's off to get inspected. I know what it looks like under the flares. It's not too bad there are a couple spots on the body that I need to fix. But I'm gonna wait to see what Santa brings. There may be a lift kit coming my way.

I got my wire and finished this mess It's all one peice now

Started to weld up the pass side frame and ran out of wire. It's put on hold for now

I made this Look like this (the red paint is just to cover it until I get some undercoat) Now I have to fix this

This is one of the bad spots in my frame. It is under the rear door on the pass side. The section I cut out. All better. 1 down many more to go

Yeah it does. Thats getting fixed.

The tip is welded solid to the bumper and the tail pipe is clamped to a peice on the inside. It does rattle on the frame a little but it's in the works to get fixed.

I moved my exhaust so I don't smash it again.

Mine were $20.00 a piece.

I went to scrap yard and got a "oh crap" handle and a switch for the rear glass. Mine wouldn't close all the way, everytime I hit a bump my window would pop open. I also seen a hardbody with manual hubs. I got home put on my "oh crap" handle on the drivers side and did some reserch and found out that the hardbody hubs would fit the pathy. I ran back to scrap yard and got hubs. Now the old girl has manual hubs. Now no more pulling forward then going backward and going forward to get out of 4 wheel drive.

Yay 28 spline !

I found a hard body at the scrapyard today and it has manual hubs. I'm just not sure what year it is. I think im gonna go pull them off and see what spline they are. I'm keeping my fingers crossed and hoping for 28.

replaced the front sway bar bushings. What a improvement.

My wife just bought a used 2003 Acura MDX. The driver side seat heater isnt working. Does anybody know anything about mdx's?

Went to the scrap yard and pulled a drive shaft out for $40 to have as a spare. I also got some trim peices.

It's camo fabric held on with some spray adhisive

My wife hates the snow camo

I spent all day Sunday at Rousch Creek.

Thanks for all your help.

Does anybody know if there is a rebuild kit for the front brakes? My calipers are shot and need something done asap. Stopping is getting a little scarry.

Fixed previous owners hack job on the turn signal wires and installed a volt meter. I can't figure out why the horn stopped working though.

I played tag with a Saturn today. Bent door, Smashed rocker, and bent rim. Looks like I'm going to the parts yart this weekend.