Leaderboard

Nissan,Suzuki,Subaru,Volvo etc. More Nissan than anything. Isuzu and Subaru switches will fit, Niles inc makes switches for several different car manufacturers. If found Suzuki switches some not all dont fit perfectly, but fit well enough to go unnoticed. Sent from my SM-S367VL using Tapatalk

Yes and yes. The relays don't require much power to operate. And the led lighting uses even less. If still concerned about adding loads, you can just add a power bus that is turned on by a relay triggered off an ignition circuit.

So i made a very last minute change. I decided to switch to the OME HD in the front. Mostly because of the amount of praise they get for ride quality. I’m going to be running the same setup as@zakzackzachary

Same as@TowndawgR50 as well & I believe both@hawairish & Myself have those with the OME struts.

EL-34 of the service manual.

Well guys here’s my Vg30e block Powdercoated. I sandblasted it first So now I’m just in the process of blowing it out with compressed air and putting a thin layer of wd40 in the cylinder walls and inside where the crank sits then wrap in saran wrap and put it in the warm house until I can take it to a machine shop. Not planning on boring, Just want it cleaned to perfection before reassembly, Have lots of parts to clean and paint before then Sent from my iPhone using Tapatalk

i’m so excited man. The amount of research required for a lift on these trucks suited to the driver definitely brings a new level of appreciation towards the vehicle.

Struts are in, spring compressor gets here tomorrow along with the OEM strut mount + bearing, bellows, and bumpstops. AC and LR springs get here next early next week. Already have the Bilstein sitting in the garage. Gonna begin the Install next Wednesday, first day off for thanksgiving break.