PATHRIDER

Ive used NGK plugs and wires and Ive also replaced my 02 sensor

If you pick one up at the jy make sure all the tabs on it are not broken.One broken tab and that cowl vent isnt going to hold in there good. I had to replace all 3 on mine just the other day and when I was trying to snap a few in place it would snap ok but soon as I close the hood itll pop back out so I did some inspection on the cowl vent itself and sure enough it has a few broken tabs so I snapped another one on there without a single broken tab and it has held fine

You dont have to remove the bolt all the way out thats inside the frame hole its got like a catch on the mounts that way if youre doing this by yourself the bumper just doesnt fall off .Lift up a little then pull out

can you tie the new sensor end to the old sensor and just pull the old harness thru

it was low yesterday when I took it to autozone and at the parking lot it was overflowing already without me having to top it off yet. Im going to try a new rad cap.I kinda thought that my rad cap is a bit loose when I removed it yesterday to check my coolant and putting it back on was the same.I hardly have to push down on it to lock it

Thanks Bry. Does it need to be oem or one that I can pick up at autozone woulod work?

Yesterday I checked my radiator and it needs some coolant so I put the cap back on and headed to autozone to pick some up.After being parked for about 15 mins there on the way back to my pathy I noticed that its overflowing from the reservoir so I top the radiator off and fill up the reservoir to the MAX level and headed home. about a few seconds after turning the motor off its overflowing on the reservoir again . I would say about a quarter to half a cup evetytime I turn the motor off.What would cause this? I know its not the radiator leaking coz the drip is coming just below the overflow hose on the reservoir on the drivers side Thanks fellas

thats an option .Tried to fit it without having to bolt it and it looks ok and its big and heavy.A nice powdercoating would make it even better. How much do you think something like that would cost if I were to have one made? I know that CBI in Idaho can make just the prerunner with winch mount for around $700 .No skids though

Thats the original size

what do you guys think of this? Im debating whether to get this for $50 and do some repainting on it. Made out of galvanized pipe so its damn heavy

A lot here uses this http://store.summitracing.com/partdetail.a...mp;autoview=sku

88path has a site that has a pathy with a 350

You can buy the closest one that will match the contour and use a heat gun to form it to shape