Leaderboard

Just a heads up, Bilstein 5100 bushings aren't sized for our rigs. Not the end of the world but you're gonna have to make a choice for the upper shock mount. 1) Mount it on the original mount bolt with some slop 2) order some bushings/sleeves to fill in the gap 3) Drill out the bolt holes on chassis with a 1/2" bit and mount a 1/2" bolt through the upper shock mount. I used option 3 and it's worked great for over 2 years so far.

FWIW I noticed that the console in a mid 90's Pathfinder was two pieces screwed together and that the upper part looked like it was about the size of the depression in the stock console in my 89. I took the 90's console apart and cut off the bottom section until it was the correct size and then attached it to my 89 console and now I have cup holders and the entire install only took a couple of hours. Not quite as nice as the OP, but it works for me. Tom