- Sign In Changes: You now need to sign in using the email address associated with your account, combined with your current password. Using your display name and password is no longer supported.
- If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.
Leaderboard
Popular Content
Showing content with the highest reputation on 11/22/2022 in all areas
-
Just a heads up, Bilstein 5100 bushings aren't sized for our rigs. Not the end of the world but you're gonna have to make a choice for the upper shock mount. 1) Mount it on the original mount bolt with some slop 2) order some bushings/sleeves to fill in the gap 3) Drill out the bolt holes on chassis with a 1/2" bit and mount a 1/2" bolt through the upper shock mount. I used option 3 and it's worked great for over 2 years so far.1 point
-
FWIW I noticed that the console in a mid 90's Pathfinder was two pieces screwed together and that the upper part looked like it was about the size of the depression in the stock console in my 89. I took the 90's console apart and cut off the bottom section until it was the correct size and then attached it to my 89 console and now I have cup holders and the entire install only took a couple of hours. Not quite as nice as the OP, but it works for me. Tom1 point