Show me your OME lifts!

[shoesandsocks]

wow 2in lower thats alot rember looking at your pics on expedition portal and it looked perfect i know mine sits about 1/14 inches lower because my springs are sagging just want to point out though my springs only have 8k on them from when the factory installed them.

Edited December 20, 2012 by shoesandsocks

[stioc]

Well, I still have to measure the height from the ground to the pinch weld seam and if it's still 16" that I remember from when I initially installed the springs then I do have 1.75" over Karmann's truck (14.25"). So we'll see.

 

It does look like it's settled down a bit since the install but I was thinking maybe 1/4" to .5" - no worries though hopefully a coil spacer will do the truck. The real ground clearance though, under the diff, only changes when you put bigger tires on, a spring or spacer doesn't make a difference.

 

You're on ExPo, cool, what screename?

Edited December 20, 2012 by stioc

[shoesandsocks]

im not on expo i just lurk i want to make one but between my military and family life i havent been able to do as many trips as i would like to dont think ill fit in on expo that much im more of a builder

[theexbrit]

From floor to pinch seam, B pillar, on mine is 16.5 inches with the AC lift. As you know, I have 31" tires like you S.

Edited December 20, 2012 by theexbrit

[stioc]

Thanks for measuring. My tire size is 245/75/16 so it's actually 30.4" not a true 31" - but close enough!

[stioc]

OK I measured it, 15.75" on the drivers side and almost 16" on the passenger side. Also, just for the heck of it I measured my tires and they're barely 30", more like 29.75" - I should've gone with the 235/85/16 with 1" wheel spacers

Edited December 21, 2012 by stioc

[sroeser01]

i measured from the ground to the center of the flair through the center cap and got 34' inches in the front and 35' in the back

[sroeser01]

i measured from the ground to the center of the flair through the center cap and got 34' inches in the front and 35' in the back

suspension 6 years old

[chazthecat]

has anybody tried this lift yet...looks good..but what do I know ...

 

http://www.krfabs.com/product_detail.php?productID=2

[sroeser01]

A bunch of pple have its a sub frame drop.

[Phantom01Pathfinder]

has anybody tried this lift yet...looks good..but what do I know ...

 

http://www.krfabs.com/product_detail.php?productID=2

Dont take this the wrong way but...have you used the search function at all??

[fistfulofpowder]

Here is my setup, It is the exact same as what projekz ran on his 97'

- 98 Pathfinder SE 4x4

- OME HD Front MD Rear coils

- OME Rear Suspension

- KYB GR2 Struts

I didn't take any measurements but the difference is very noticeable, Here are some before and after shots of it From June until Now:

[sleeper00]

Any major reasons why you guys run the KYB struts over the OME?