94pathfinder Posted February 18, 2010 Share Posted February 18, 2010 so after dropping the transmission out of my truck, and watching the bad one roll off of the tranny jack, i realized maybe if i had removed the transfer case, it would have been easier. So my thoughts are removing the transfercase, and the install it once the transmission is in the truck. so once i remove the transfer case, what is going to pop out and bearings, or what not, or just the output shaft fron the transmission. Thank you for you're help John Link to comment Share on other sites More sharing options...
beastpath Posted February 18, 2010 Share Posted February 18, 2010 nothing pops out. its a complete unit and the shaft just slides into the transmission Link to comment Share on other sites More sharing options...
94pathfinder Posted February 18, 2010 Author Share Posted February 18, 2010 thank you Link to comment Share on other sites More sharing options...
MY1PATH Posted February 18, 2010 Share Posted February 18, 2010 well if its a manual transmission the last 1/2qt of oil thats in the tranny will spill out because it seals against the t-case. put a bag or someting over the end so dirt from your under carrage doesn't get inside. this little bit doesn't come out when you drain becase there is a rise in the casting to the output bearing that separates the last section from the drain plug. If its an AT forget everything I just said all will be fine. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now