Stinka

Or these from a '96 jeep cherokee

So, will WJ front springs fit and give a lift ? Can get bloody hundreds of those here in uk, but v8 zj springs are like hens teeth These are them:

Also, the side steps are crap, they are mounted on 3mm angle steel section, bent them on the first outing, keep bending them straight, but they are wrecked now Will build a proper slider type thing from 50x503mm box section and remount them on the side of that

Cheers lads, its a td27 engine It has the bosch injection Its had a total nightmare of running problems over the last 3 months It was missing and smoking on start up, so i replaced the glow plugs, 2 of which were dead, then it started smoking again and was undrivable, so i put a new maf sensor in and then it was much better. after that the black smoke started again, randomly, and I blanked the egr valve on the inlet manifold side, which sorted it. Finaly it started going into limp mode after it warmed up, traced that to a split intercooler, where the tubes join the end tank, which was expanding once hot and the sensitive ecu just put it in limp mode. Intercooler comes tommorow from ebay, so fingers crossed its fixed as its been doing my nut in. Then hopefully gonna get some JGC rear springs and crank those torsions, also some gas magnum ford bronco front shocks, and a mate from another uk forum has some Extended RC rear shocks, so getting some from him Its getting there anyway

Ok, so I have a terrano R20, which uses wd21 chassis and suspension. Now I just got me some '97 grand cherokee v8 front springs off ebay, as I just read on here that they will give me 3" on the rear. What do i need to do to the front to get it up 3" ? I read that you can only crank 2" on torsion. So i can get some spacers for the ball joints off ebay : http://www.ebay.co.uk/itm/330684975920?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 Will these give me an extra 18mm lift ? As if I crank 2 inch plus the 3/4 inch from these spacers would be fine i think ? What are your thoughts ? Cheers

Based in staffordshire in the midlands Driving a '02 terrano r20 which has same chassis and suspension setup as the wd21 pathy/terrano some pics of my ride: NEED SUSPENSION LIFT NEXT !!