Tungsten

Inflated from 26 psi to 36... haven't driven it yet, but if the massive reduction in sidewall bulge is anything to go by, it should handle a little better now!

Timing belts are even more fun to install than to remove.

And just ordered some Thorley headers from Rugged Rocks. SteevoO owes the Red Hook brewery a commision for my drunken purchase.

Pulled out my airbox resonator today. Inside I found three pieces of corn. Something's been in this truck.

And just ordered some Thorley headers from Rugged Rocks. SteevoO owes the Red Hook brewery a commision for my drunken purchase.

These VG30E timing belts are so easy to do and people complain...

Just ordered new Yokohama Geolander tires and a high lift jack!

After removing .7 million vac lines, tb, steering pump, alty and fuel lines I have been stoped by a damn T40 torx bolt. Now I have a 3/8 T40, but it dont fit snug. I need a 1/4...

These VG30E timing belts are so easy to do and people complain...

It's amazing what a dirty EGR valve can do...

It's amazing what a dirty EGR valve can do...

Gates water pumps suck. Going back to Nissan.

Gates water pumps suck. Going back to Nissan.

Gates water pumps suck. Going back to Nissan.

Gates water pumps suck. Going back to Nissan.

why is the stock exhaust diameter so small?

why is the stock exhaust diameter so small?

Well My NOW wife and I got up to our own wedding! I put everything together just in time to leave town and get to utah! Damn the VG33E has a BIG noticeable difference then the VG30E !

Successfully replaced and rekeyed my driver and passenger door locks to match my ignition, now just the rear hatch glass and glovebox and i will have one key for my whole truck! finally, the way it should be! anyone want a how-to?

Rear passenger door sills.. anyone know where to purchase new ones?

Nissan Y U NO keep the same taper?

Nissan Y U NO keep the same taper?

Hmm..any way to make an R50 overhead console work in a WD21? Or am i just dreaming again...

Jacked up the truck with correct alignment. Still out of caster but whatever it drives straight and I'm not in the mood to shim those tension rods. I'll just wait until they wear again. lol

Finally fixed the hinge bushings in my spare tire carrier. Wow what a pain.. upper hinge pin was easy, bottom one took some serious help to get out. Got er all done and no more rattle going over bumps!! Finally opens and closes properly too. It even opens itself once the latch is released! So cool ...