Leaderboard

Was it the 36R0788 like you have listed above? Where did you get it? Yeah that’s the one I installed. Everything has been great so far. And I ordered from summit racing and it took about a month to get to me as they ordered from the manufacture. Didn’t have in stock. Rockauto has it as well. It says 2 day delay but I’m not sure if it would be longer. Sent from my iPhone using Tapatalk

It wasn’t bad honestly. I tied down the steering wheel first with it centered. I removed the splash guard underneath and then the sway bar brackets, allowing it to drop down. Then I loosened the banjo bolts on the two lines and all the fluid will leak out now so have a pan. There is a single bolt on steering shaft that has to be removed. Then I unbolted the rack and pulled it down and out. Make sure you check back if the new rack is centered. I got a ACDelco and they had said in the instructions it’s centered at factory but it wasn’t. You can use a vise grip pliers and a cloth on the shaft and turn the shaft from lock to lock to count the total turns. And then turn back until it’s half that amount and you’re centered. Installing is simply the reverse and then fill it up with fluid once everything is bolted up. Turn the steering wheel lock to lock several times with engine off and wheels still up in air. Then turn the engine on and turn lock to lock again several times. All the air should be out the system now. Make sure to use new copper washers on the banjo connections. And when installing tie rod ends count the threads on the old rack and set the new one to the same so you’re alignment is close enough until you align at the shop. Took me about 3 hours. I definitely wouldn’t pay that much to do it. Sent from my iPhone using Tapatalk