Leaderboard

Quick update. The Wilco dual rotopax bracket, license plate relocation bracket, and rotopax pack mounts, fuel cans, and a water can came in a couple of weeks ago. Finally had time and good weather today to mount them up to the Wilco Hitchgate: The next project will be to figure out a way to wire in some LED bolt lights I got to use as license plate lights. Anyone know a good way to get some wires inside the cargo area from underneath? May have to drill but we’ll see... Also got a chance to head up to Mount Hood for a little snowshoeing last weekend. First chance to try everything out in the snow. There wasn’t a ton of snow until the last 1/4 mile or so on dirt roads but these tires seemed to hook up very well and there was almost no slipping. So far very pleased with the build and looking forward to more winter outings in the next couple of months!

Perfect! I figured there must be a way in but this will save me some time. Thanks!

I've never searched for the hose before, but you can measure the inside diameter (ID) and just search " whatever the ID is" 90° hose and anything close to the size should work. Honestly I'd go slightly bigger if you can find and use some tighter hose clamps, it's in such a tight spot, the only part I hate about removing the intake. Mine cracked pretty bad several years ago, I have it just taped up so it's a looser fit and haven't had any problems. I could be wrong but I'm pretty sure it goes in before the filter anyways so if any dirt did get past wouldn't be a big deal, could still cause a vacuum problem though. I can figure out the thread tomorrow, my truck is at work under repair, I can yank it and see what thread pitch it is and let ya know.