Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

which way does it go?

turbopath

By turbopath,
in The Garage

 Share

Recommended Posts

turbopath NPORA Fulltime Resident

turbopath

Posted
Posted

Ok, I was putting my new spindle on my R50 this morning and I realized...I don't know which way the copper washer goes into the spindle. (outer axle) Does the dish point out towards the wheel or in towards the trans? Same question with the axle retaining nut. Small edge out or in.

Link to comment
Share on other sites
turbopath
NPORA Fulltime Resident

turbopath

Posted
  • Author
Posted

whew, I didn't want to pull the spindle to flip it around. haha. It seemed like it would logically go against the bulbish end of the axle, but I could also see it being chamfered to prevent contact with the needle bearing. I'm kinda thinking the retaining nut might not matter. I put it on the way it came off, but I seriously doubt the skill of the person who worked on it last.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...