MaritimeMan Posted March 10, 2006 Share Posted March 10, 2006 (edited) Does any one have a compression tester guage that they recommend? I have been usin my room mate's, which is nice, but I can't get it tight enough to seal, and since the plug holes are so deep, it's nearly impossible to get a wrench in there to tighten it. What I am thinking is some sort of solid tube that could be tightened from the top, then the guage connected to that. Is there anything like this out there? Thanks for any advice and or recomendations. M.M. Edited March 10, 2006 by MaritimeMan Link to comment Share on other sites More sharing options...
88pathoffroad Posted March 10, 2006 Share Posted March 10, 2006 Mine has a brass plug end fitting with an o-ring on the end of a hose, then the gauge goes on the other end. Screws into the plug hole, just twist the hose a bit to tension it up and it's done. Link to comment Share on other sites More sharing options...
RedPath88 Posted March 10, 2006 Share Posted March 10, 2006 Mine is the same as his ^^^ MM is it possible that the one you are using is missing a rubber O-Ring to seal to the cylinder head when you twist it Link to comment Share on other sites More sharing options...
MaritimeMan Posted March 10, 2006 Author Share Posted March 10, 2006 Nope, the one I am using has the O-ring at the attachment point. I preload it like 88 said, but when I turn it over, I get a hiss of air getting past. Maybe I'll just go buy a different one and try that. Link to comment Share on other sites More sharing options...
Slick Posted March 10, 2006 Share Posted March 10, 2006 samne set up as above, dave got his at kragens.. like $34 or something... worked great on my pathy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now