4runnerfinder Posted November 22, 2014 Author Share Posted November 22, 2014 Anyone put a bronco radius arm sas suspension on! Link to comment Share on other sites More sharing options...
Slartibartfast Posted November 22, 2014 Share Posted November 22, 2014 Yup: Link to comment Share on other sites More sharing options...
devonianwalk Posted November 22, 2014 Share Posted November 22, 2014 Nice link! Link to comment Share on other sites More sharing options...
4runnerfinder Posted November 24, 2014 Author Share Posted November 24, 2014 Thanks for the link! Got a bronco parts truck lined up for some yard work..! Link to comment Share on other sites More sharing options...
4runnerfinder Posted November 24, 2014 Author Share Posted November 24, 2014 1 Link to comment Share on other sites More sharing options...
4runnerfinder Posted November 24, 2014 Author Share Posted November 24, 2014 As in, im doing 6-8 hrs of yard work on Wednesday, and receiving this parts bronco for my work! Link to comment Share on other sites More sharing options...
CO_pathfinder Posted November 24, 2014 Share Posted November 24, 2014 niceeeee Link to comment Share on other sites More sharing options...
4runnerfinder Posted November 25, 2014 Author Share Posted November 25, 2014 Holding off on that bronco. Even as much as i want it, its a lot of rust.. I found a set of aluminum factory wheels to throw on, will the 33x10.50s be ok on a set of the 15x8s? Or at least 32s? And, is this red path lifted, ya think? ^^. Either way thats about the tire size I'm shooting for, and then just build the internals. Thanks again for all the input, and yet another chill forum. I posted briefly on pirate, then completely remembered why i never post on there. Guess i don't drink enough monster or roll coal often enough to care about those opinions! Link to comment Share on other sites More sharing options...
4runnerfinder Posted December 2, 2014 Author Share Posted December 2, 2014 Ok, to clarify. Im holding off on the white bronco, but i did the yard work for the green bronco, so a radius arm sas pathfinder may be on my horizon... The link was nice, but if anyone has direction to a write up on the radius arm & rear axle swap I'm all ears, or eyes, or whatever. I just wanna know if i need to reposition spring cups/ reconfigure driveshafts if necessary due to lift(?) w sas/ rear spring/coil/ rear set up w minimal lift and fab. I am thinking fully locked rear and 33's/35s w nice trim job.. Do i need different coils? Any coil suggestions as far as which fit? Coil cups? S Just the usual questions in mod land, and just like anyone else i would like to yield the most amount of 4x4ability for the least amount of $$$. Im well on my way, mahalo to all Oh i have some photos of abandoned cars to trip ppl out! Link to comment Share on other sites More sharing options...
4runnerfinder Posted December 2, 2014 Author Share Posted December 2, 2014 Link to comment Share on other sites More sharing options...
4runnerfinder Posted December 2, 2014 Author Share Posted December 2, 2014 Common occurrence. I took some heavy speaker wire, it was pretty well handled by the time i found it.. Just up the road about 5 min drive! Should have got more... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now