MY1PATH Posted July 20, 2008 Share Posted July 20, 2008 (edited) I we put a moser 9" w/ 3.89 gears in my friends 99 z28 and we also swapped to a newer aluminum diveshaft. He said I could have the old aluminum one and said it would be neat if I could get it on the pathy. that being said I took some measurements; center to center i think it was close to . Pathy 36.75" Camaro 40.5" That being known, does anyone know how deep tranny yoke will slide in? It might work @ ride height but with the more than 3" extra will it slam something B4 suspensoin can bottom out? Edited July 20, 2008 by MY1PATH Link to comment Share on other sites More sharing options...
unccpathfinder Posted July 20, 2008 Share Posted July 20, 2008 the spline count is probably different...If theres a good shop in town you could have the camaro 1 shortened...a couple of inches is a good bit of axle length to make up... Link to comment Share on other sites More sharing options...
MY1PATH Posted July 20, 2008 Author Share Posted July 20, 2008 (edited) the spline count is probably different...If theres a good shop in town you could have the camaro 1 shortened...a couple of inches is a good bit of axle length to make up... I would use the slip yoke off the paty Edited July 20, 2008 by MY1PATH Link to comment Share on other sites More sharing options...
unccpathfinder Posted July 20, 2008 Share Posted July 20, 2008 I still dont see it working if you dont shorten the shaft... Link to comment Share on other sites More sharing options...
GrimGreg Posted July 21, 2008 Share Posted July 21, 2008 You'll have to remove that extra 3", you'll actually do the damage on droop. Look at which direction your trailing arms swing . I assume you already checked that the U-joints were the same size, if not might as well get the ends swapped while the shop is shortening it. Link to comment Share on other sites More sharing options...
MY1PATH Posted July 21, 2008 Author Share Posted July 21, 2008 (edited) Thanks, I guess I was visualizing it backwards. edit: Also If anyone wants a used cevy 10-bolt w/ 3.43 gears(IIRC)PM me for details Edited July 22, 2008 by MY1PATH Link to comment Share on other sites More sharing options...
Nissyota88 Posted August 12, 2008 Share Posted August 12, 2008 Thanks, I guess I was visualizing it backwards. edit: Also If anyone wants a used cevy 10-bolt w/ 3.43 gears(IIRC)PM me for details Your pretty much just putting on an aluminum shaft... whats the point? you need the nissan flange and the nissan yolk slip other then that your fskcked and if not more worse... go ahead and try to find someone that wants to weld the aluminum... for cheap Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now