Wiper Covers

[ennacac]

OK, the black plastic covers under the windshield that cover the wiper rods, just went away in the car wash when the 200mph dryer started up never to be seen again. Any suggestions for a better way to hold them on other than the lame plastic rivets Nissan uses?

 

Tom

[unccpathfinder]

assume your talking about the "cowl vents" and yea you can use some nutplates and screws or something like that... or sheet metal clips (like what hold the fender flares to the fenders and put screws through those)

 

serach around I had a thread after one of them was stolen...search cowl vents or something like taht... theres a lot of ideas in that thread

[GrimGreg]

I made mesh ones for mine and just glued the mesh in place.

[ennacac]

Thanks I found the thread. Looks like many of them go flying off, so I will just use clips and screw them down from no on.

 

Thanks

Tom