Search the Community

I've been researching what shocks to get for my 4" lifted QX4 and I've settled on the 5165 but I'm not sure what bushings i need to fit into it. I read in some posts that it is a necessary step. And its understandable of course since the bushings are unsupported sizes for the r50. Is there a part number anyone could provide me for 5/8 bushings that fit the 5165 25-261400's? I saw that Jax99 ran that model. Also are there any inconveniences or tradeoffs anyone experiences from running the 5165s with the external reservoir? Things like whether or not the tube rubs the tire. My front end is spacer lifted 2.5" and my rear has LR 9448/9449 coils providing 4" of lift. I had looked at the 5165 25-187748 because it has a 17.93" compressed length which is very close to some 5125's (33-185569) I've seen some people running that have a 17.91" compressed length (with 11.8" travel). However the 25-187748 5165 has 17.93" compressed length AND 13.1" of travel. Which is quite an upgrade. Not to mention both of these shocks use 5/8 bushings for both top and bottom. Is there something I'm missing on why people aren't using the 25-187748 5165's? I saw one or two posts about people using the 25-261400's. Those come stock with 12mm eyes. To me at least it doesn't quite add up on why people would buy shocks that have incorrectly sized bushings that they have to switch, over just getting a model that has 5/8 eyes to start that, (to my knowledge) work on the r50 out of the box. But there may be something I'm not aware of. The way I see it, the 33-185569's seem objectively better due to the higher travel. And the fact that it has the same mounting length as other shocks I've seen r50 owners run means i know that the length is supported. And the 5/8 fitting seems perfect as I wouldn't have to switch the eye out. This is the parts+size chart I used - https://www.shockwarehouse.com/pages/bilstein-b8-series-measurements Sorry if this is a big information dump and a lot to ask but any info helps. I appreciate anything. Thanks in advance

A bit of a long shot here BUT anyone happen to have extra r50's/ parts laying around? looking for trunk hinges for my 2004 Pathfinder. I have tried looking online and calling several body shops but they seem to be impossible to find. Any help/ recommendations would be greatly appreciated!! thanks

So I have really done it this time.. pulled the engine off of a 2001 pathfinder with a 5 speed and I broke the front cover. Just was wondering if anyone out there had any good suggestions for a place to get the parts. The piece that I broke is the front cover and I've searched high and low. cross referenced the transmission model and found a front cover but unfortunately while bolting up I discovered that it will not work. I am up in Canada and our selection is limited. Thanks to all in advance.