Jump to content

Due to a hardware failure on the hosts systems, all posts and messages created between May 26th and Jan 13th have been lost. Additionally, if you joined the NPORA Forums community during that time, you'll need to re-register. -NPORA Mod Team *Updated: 05/19/2022 12:15AM PST


  • Posts

  • Joined

  • Last visited

  • Days Won


Posts posted by johann_peralta

  1. About a year ago I had this same problem and eventually figured out part numbers,  sizes, and was able to replace all the joints without problem. Unfortunately a year later all I have left in my notes are

    "rear flange hole distance 2 11/16"

    "front flange 2 1/4"

    "rear joint 3 1/4"

    "F 1 1/8"

    If I recall 2 of those were Nissan sizes, 1 was Jeep, and 1 was Ford. Sorry I know that probably useless. But maybe it can help. Good luck. 

  2. On 10/8/2020 at 12:01 AM, mjotrainbrain said:


    Geez that's huge! Now that it's been done for a while, what are your thoughts? Anything you'd still like to change, or would do different next time? How well does it go down the road, any big issues with shaking or death wobble? I'd imagine that little V6 is struggling with those meats, even with good gearing.

    If I had to do another SAS (Im planning on another once I graduate), I'd lower it some (around 4-6" total lift), change the angle and mounting location for the upper mount of the coilover/airshocks, put the axle side coilover/airshock mounts an inch wider on each side, ditch the doubler, make a different trans crossmember with a slot for the front driveshaft, triangulated 4 link instead of parallel, ditch the cradle. In an ideal world, I would sas a 3.5 next time. A bigger motor couldn't hurt either..

    Overall I think it was fine considering it sat around 26" of lift. Less lift would solve so many of the headaches. 


    I never experienced any death wobble or shaking luckily. 

    • Like 2
  3. On 9/2/2019 at 10:01 PM, MY1PATH said:

    Update: It appears the company Iciba, who makes the 122555S 55mm stud does not include the knurl in their measurement. These ended up being 5mm too long and would bottom out on the lug nut. I am working with SNC on the matter right now to get the correct fitment.

    Not sure if this helps your situation, but the rear r50 studs will fit in the front. They sit very snug. I did this swap myself a few years ago for the extra length. I got the studs for under 2$ each at the time. 

Welcome to NPORA Forums


Please register to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.



  • Create New...