Jump to content
Sign in to follow this  
superfrog13

Wiring guide for window/lock panel connector 2003 pathy

Recommended Posts

I was a little too forceful removing the connector from the main circuit board under the window/lock panel on the driver's side and the connector exploded leaving all the plugs free.

 

Does anyone have a picture of the wiring into the connector to help me match up the wires in the replacement connector?

 

🙏

Edited by superfrog13
wrong forum - The Garage

Share this post


Link to post
Share on other sites

Hopefully someone's got theirs apart. Best I can do is page EL-262 of the '03 service manual, but it looks like a bit of a pain to translate the diagram into a pinout for the plug.

Share this post


Link to post
Share on other sites

Thanks. I stared at this for hours the other day and looking at it again it only gets me about 80% there. I'm not great at reading wiring diagrams. Assuming I know whether G means Green or Grey!

 

I see more descriptions for pins in the diagnostic procedures which gets me a little farther along (But what's the difference between W/B and W/B?). Hopefully, I can make an educated guess as to the last 2 pins that I don't see anywhere else in the guide.

Share this post


Link to post
Share on other sites

Again, thank you for pointing me toward that. Before, I wasn't sure if I was going to get all the info I needed, so the assurance was helpful.

 

And with a little deductive reasoning,  I have it figured out. 

 

Forgive my ignorance, but here's what I learned:

 

LG = Light Green

L = Blue

G = Green

B = Black

BR = Brown

Y = Yellow

Y/L = Yellow with Blue stripe

G/Y = Green with Yellow stripe

and so on...

 

Also, I only counted 14 plugs (not the 16 capacity of the connector) , so I guess I'm covered. Even with the chaos of their being out of the connector, the general order that were holding made it fairly clear which W/B is which - one is thicker gauge (pos. 7) than the other (pos. 2).

 

Mocked it all up in the broken connector and tested the layout - EVERYTHING WORKS! So, when the new connector arrives, I'll be ready.

 

Thank you. Thank you.

 

 

 

Share this post


Link to post
Share on other sites

Good job sorting it out! L = blue took me a while too. There's a key somewhere in the manual, but I didn't know that at first.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

Welcome to NPORA Forums

 

Please register to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.

 

-NPORA

×
×
  • Create New...