Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Chamber Spec

neilca

By neilca,
in 96-2004 R50 Pathfinders

 Share

Recommended Posts

neilca NPORA Veteran

neilca

Posted
Posted

I replaced a bunch of parts in the front end and lifted it 2 inches. I have camber bolts in the top hole of the strut. Now how much chamber do I need. The only spec I have found says 0.17 positive degrees. I have never set up a car with positive camber. What is the factory spec for camber?

Link to comment
Share on other sites
hawairish NPORA Old-Timer

hawairish

Posted
Posted

0.17° is correct, with a min of -0.58° and max 0.92°. Difference between the L and R side should be less than 0.75°. Values are in the FSM, in SUspension chapter. Check the SDS section at the end of Front Suspension.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...