bushnut Posted August 28, 2016 Share Posted August 28, 2016 this weekend I was headed out to a music festival. Had the cruise on at 104 kph. 40min into the trip and it just cut out. throttleb still worked but no speed was being shown on my Ultra Gauge. Cruise control light was blinking. pulled over. temp was good, battery good, idle was normal. no codes being shown. turned off the truck and restarted. everything was fine.....didn't use the cruise any more until I got to the festival. Had a great time BTW. I did use it the whole drive home yesterday. about 1h drive @ 104-5 kph no issues....what gives? anybody have this happen before? Link to comment Share on other sites More sharing options...
RCWD21 Posted August 28, 2016 Share Posted August 28, 2016 What vehicle do you have? If the cruise actuator is vacuum controlled, check to make sure the vacuum line is good. I've had mine split before where you can't see it on the back side of the actuator and it drove me crazy until I actually inspected the line and found a small split in it from drying out Sent from inside my potato Link to comment Share on other sites More sharing options...
maddmark1981 Posted September 8, 2016 Share Posted September 8, 2016 It happens to me all the time, my rpm and speed guage cuts in and out, faulty instruments Sent from my LG-D852 using Tapatalk Link to comment Share on other sites More sharing options...
bushnut Posted March 5, 2017 Author Share Posted March 5, 2017 so happened to me again this weekend...traveling along at 100 kph hit the cruise...all good for about 60seconds....then hiccup ...start to loose speed, cruise control light in dash flashing, press accelerator... nothing. turn off Cruise at switch on dash board.nothing. Pull over to the side of the road and turned off the truck and re-start. all good. didn't try to use cruise for the rest of the weekend. did a 400km+ drive and no other issues was running like a champ. until I realized that on steep hills the transmission does not step down to a lower gear from OD unless I use the button on the gear selector. Is this relay or vacuum controled? throwing no codes but were should I start looking? Link to comment Share on other sites More sharing options...
maddmark1981 Posted March 7, 2017 Share Posted March 7, 2017 Mine does it too.. Sent from my LG-H812 using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now