Clutch fluid missing and no pressure on clutch

[KILLANOLA]

I found my 95 pathfinder -XE 5 speed with the Clutch fluid missing and no pressure on clutch this morning. This happened about 5 or 6 months ago also and I used one of those pressure pumps to get the air out and fluid back in the system. But unfortunately That's not working this time around. There is still no pressure on the clutch pedal. I tried to pump it like last time but no pressure on it. All thoughts and ideas would be great appreciated as I'm kinda a notice when it comes too working on cars.

 

Thanks,

KILLANOLA

[NP670]

Just finished working on mine...1. Check master cyl... 2. Check Slave... 3. Check clutch hose... 4. Check your pipings...

 

Possible that there might be a leak somewhere

 

Sent from my SM-N910T using Tapatalk

Edited June 21, 2016 by NP670

[KILLANOLA]

Im not really sure where those are located or look like?

[KILLANOLA]

I check 1 and 4 not sure where 2 and 3 are

[dirtbike23]

2/3- located/installed @ chassis near bell housing. just follow your clutch line from CM going down to your slave cylinder

[NP670]

 

Sent from my SM-N910T using Tapatalk

[NP670]

Heres the clucth hydraulic system. Follow the piping or tube from the CM to the clutch damper, then from the damper down to the clutch hose. Make sure your hose is not worn or cracked. Then check the clutch slave. Try bleeding the damper till fluid comes out, then, Bleed the slave after. Hope this helpz[emoji4]

 

Sent from my SM-N910T using Tapatalk

Edited June 24, 2016 by NP670