Snowboarder12345 Posted January 13, 2017 Share Posted January 13, 2017 Ok, sorry it took me a couple days to get back to you, but here ya go: They aren't pretty but they seem to do the job so far. I haven't really done anything to stress test them yet though so we will see. Right now they are held in place by the pressure of the spring, and I may just end up welding them in for peace of mind. so basically the pipe is welded to a circular piece of plate, and the spring end butts up against the joint. There are only 3 tabs holding the pipe and plate together as the piece of pipe isn't load bearing, they are just there to keep it in place. what you can't see here is the second piece of plate up above the lower one. it is angled to match the frame and sits flush up where the stock spring used to sit. You can see it in the lower picture. I also realize they are quite crude and very unprofessional looking, but I don't really care as no one was supposed to ever see them Here's roughly how the pieces of plate sit from the side. Hope this helps. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now