Rebelord Posted April 11, 2013 Share Posted April 11, 2013 (edited) Guys, need some knowledge here. I have been scouring the web and I cannot find the stock wheel specs for my wheels. This is driving me bonkers atm. Reason is, I am wheel/tire shopping. Not quite ready to buy. But getting my "wish list" down. These are the wheels I have that I need the specs for: Factory SE 15x7 6spoke alloy wheels. These are the wheels I am looking at: Level 8 Scorpion 16x8.5 available in 18mm or -6mm offset. Depending on stock wheel specs determines which ones would provide the fit I am looking for. TIA! Rebelord Edited April 11, 2013 by Rebelord Link to comment Share on other sites More sharing options...
Alkorahil Posted April 11, 2013 Share Posted April 11, 2013 (edited) Nissan is very good about stamping lots of information on the wheels. If you look on the back side of the spokes on the R50 and R51 wheels, there should be stamped: 1) last five of the wheel part number looking like XWXXX where X= a number 2) The offset, 3) DOT/JDOT approval, 4) width and dimension of the wheel 5) the maker's mark For the WD21 alloys this information is stamped on the outside of the lego wheels Edited April 11, 2013 by Alkorahil 1 Link to comment Share on other sites More sharing options...
Rebelord Posted April 12, 2013 Author Share Posted April 12, 2013 Didnt take the tire off yet. Yes, on the outside I have the usual 15x7 JJ some JJWWMM squigly markings. JDOT. Took a peak on the inside. There was some stuff caked up. But about the only thing I saw was WN5/S? and possibly a 40. But Ill have to take the tire off tommorow to be sure. Link to comment Share on other sites More sharing options...
Alkorahil Posted April 12, 2013 Share Posted April 12, 2013 Didnt take the tire off yet. Yes, on the outside I have the usual 15x7 JJ some JJWWMM squigly markings. That is the maker's mark. Took a peak on the inside. There was some stuff caked up. But about the only thing I saw was WN5/S? and possibly a 40. But Ill have to take the tire off tommorow to be sure. 40 is the offset Link to comment Share on other sites More sharing options...
Rebelord Posted April 12, 2013 Author Share Posted April 12, 2013 Sounds good. Probably take a wheel off today to clean up and verify. <br />If it is 40mm then the wheels i like that are 16x8.5 and +18mm offset. Giving that the offset calculator is right. Would give me 3mm more clearance inside and outside would extend out 41mm past stock. Which will fit very nicely IMO. <br /><br />Sent from my Galaxy Nexus using Tapatalk 2<br /><br /> Link to comment Share on other sites More sharing options...
Trogdor636 Posted April 12, 2013 Share Posted April 12, 2013 That is the maker's mark. No, this is Makers Mark! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now