T case wire harness

[SimplyRed]

my 2001 pathy got to hot pulling our trailer and melter all the wire harness near the transfer case. We rewired the transmission wires, but the transfer case wires are all melted together. I need a replacement part. Dealer doesn't know or show proper harnees and no wreckers have any 2001 pathfinders. Where could i get the short harness from the transfer case to the floor board?

[NavyP503]

I had the same thing happen to my '91. Replacement harness was $75 and they weren't even sure it was the right one. I just cut out the melted wire, spliced in new wire and put new wire loom on it.

[SimplyRed]

The dealer here weren't too much help, they weren't sure if the sub harness was what I wanted. We got the wires to the tranny done, the ones to the T case are melted so bad that its hard to tell which wires go where. We are gonna attempt it in the morning 1 at a time. No wreckers have any Nissan around here, only 97 or older. Thanks for the reply.

[nunya]

I'd print out a wiring diagram and just run some fresh starting where your wires are still good honestly.

[NavyP503]

I was going to run completely new wire to the stock plugs, but couldn't find the correct crimped terminals anywhere. Good luck on the wiring!

[MY1PATH]

if its a manual shift T-case the wires only run the dummy light...