zelix Posted November 17, 2010 Share Posted November 17, 2010 how do you remove the torsion bars? i have a 95, just need to know cause i need to get the tranny out. thanks Link to comment Share on other sites More sharing options...
sewebster Posted November 17, 2010 Share Posted November 17, 2010 (edited) From memory: -jack and support the front of the vehicle -loosen the locknut on the top of the long adjustment bolt at the back -completely lower (loosen) the bars -slide the dust covers away from the ends (front and back) -mark where the bar goes into the torque arm at the front so you can put it back in the same place -remove the anchor bolt at the back entirely, keeping track of where are the pieces go with orientation -remove the snap ring at the rear that prevents the bar from sliding back -slide the bar back -if it doesn't come out at the front, you might need to try harder, or possibly loosen/remove the torque arm (which is the small plate held on by three bolts). This could be annoying. Edited November 17, 2010 by sewebster Link to comment Share on other sites More sharing options...
ahardb0dy Posted November 18, 2010 Share Posted November 18, 2010 If the bar won't come out I hit it with a rubber mallet while pulling on it towards the rear Link to comment Share on other sites More sharing options...
andreus009 Posted November 18, 2010 Share Posted November 18, 2010 If the bar doesn't slid back out of the front with the front tires fully drooped try jacking up the A-arm some. I've had this help get the bar out without having to disconnect the connection point at the A-arm. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now