Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

O2 Sensor Wiring

Ultrafinder

By Ultrafinder,
in The Garage

 Share

Recommended Posts

Ultrafinder NPORA Regular

Ultrafinder

Posted
Posted (edited)

I just got a new o2 sensor in the mail. It was supposed to be direct fit but, it's about 2' short. Being in a bind I cut the existing wire and spliced in the new o2. I got the black wire, duh. Does it matter with the 2 white wires? One is ground and one is signal?

Edited by Ultrafinder
Link to comment
Share on other sites
Precise1 NPORA Old-Timer

Precise1

Posted
Posted

I would make sure that the corresponding wire orients with the plug at the end, I believe it is uni-directional. I'm not sure if it matters, but this is what I would do.

 

If you have cut the old one before now, wait for further input...

 

B

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...