Complete Cat-back exhaust systems

[Jeffrey]

Anybody out there been able to find a reasonably priced complete stainless steel high flow cat-back exhaust system.

I've looked at alot of the aftermarket companies like Summit, but it seems as though I'll just have to piece my system together.

If I go this route, will 2.5" piping kill my low end torque? I'm thinking magnaflow high flow cat pn#22760 to a flowmaster 50 series

muffler will be the way to go.

[edicer2]

i put a flowmaster 40 on mine and a magnaflow high flow cat and it sounds good i only put on 2.25 inch though

[Jeffrey]

Is your 40 series pretty mellow sounding when you're not hammering the throttle?

By the way your Pathfinder looks badass.

Edited July 17, 2009 by Jeffrey

[Kingman]

I had a magnaflow hi-flow cat and a Flowmaster 40 series on mine as well and it sounded extremely good. It had a raspy and burly idle note and when you put your foot in it the tone was nice and deep and linear. I did 2.25" as well.

[MY1PATH]

borla makes a 2.5" cat-back but yes it will remove your bottom end. Here's what I have, I'm pretty happy with it.

http://npora.ipbhost.com//index.php?showto...st&p=408591

[Jeffrey]

borla makes a 2.5" cat-back but yes it will remove your bottom end. Here's what I have, I'm pretty happy with it.

http://npora.ipbhost.com//index.php?showto...st&p=408591

 

Thanks for the info and the audio demo. Your rig sounds great- I think I'll stick to piecing together my new exhaust with 2.25" piping as I can't aford to give up what little torque I've got now.