Brush Guard Mounting 95 Xe

[placeandshow]

Where is the typical mounting sites? I need to fabricate some brackets to modify this brush guard I got.

Edited May 26, 2007 by placeandshow

[placeandshow]

I meant it's a 94 XE

[Simon]

My stock nissan one mounted to plates that attached where the stock tow hook is. That's also where my ARB mounts.

[88pathoffroad]

There are also some 90 degree twisted brackets that go through the bumper holes and attach to the frame near the middle on each side.

[placeandshow]

It came with some 90 degree twists, which bumper holes RU talking, THE turn signal grill?

[SaKaNa]

I may not be an expert on the WDs, but uh... that brush guard doesnt look like its designed for a WD OR an R50...

[placeandshow]

no it's an Xterra brush guard from nissan it's gwanna nearly touch the fenders the way it bends back

[Slick]

no it's an Xterra brush guard from nissan it's gwanna nearly touch the fenders the way it bends back

if that's the case, i would weld up some extensions while i'm at it so it doesn't touch yer hood or fenders.....

[Simon]

It shouldn't hit the fenders at all, actually. The Xterra's body is wider than the WD21 Pathfinder. It'll probably stick out a couple of inches on either side.

Edited May 27, 2007 by Simon

[placeandshow]

Xterra may be wider at the bumper, but not at the headlights. The xterra slopes toward the windshield and Pathy is pretty flat.

On my first attempt of mounting, it rested on the turn signal and my hood wouldn't open.