vengeful

No Cross Posting.....you should know better than that... This will be deleted at Midnight PDT.

Wierd...and here I thought CA had the smog nazis...VA wouldn't pass me because the KS DTC was present. pssd

When my wheels were bent/out of balance, it would vibrate the brake dust sheild against something and create an awful racket between 15-20mph. Not sure if that's whats going on with yours, but it might be something along those lines.

Dean, You say you've had the KS code for 3-years? How do you pass smog? Path98, Generally, in order to replace the rotors on a Pathfinder, you have to repack the wheel bearings. If the bearings weren't repacked, there's a good possibility that they are off-center.

That may be indicative of the typical resistor failure. Try searching around the forums for climate control resistor or the like.

After installing the spacers, your alignment needs to be re-checked. You're probably toed-in. You also need to re-align the steering, too, if that hasn't been done.

ACs skids are horrible. Go with the BlackPanthers. I've had both...I still have the BPs.

They're not at all Ryan. You have an answer in your post in the R50 section. I'm going to merge the threads after a little while.

Check your dimmer switch. If it is the bulb, you have to remove the cluster to get at it. You can't get at it under the hood.

The QX4 has a rear glass release. The actuator is actually built into the latch itself. All you'd need to do is swap out your latch for the QX4 Latch and toss in a momentary switch to energize the actuator. Easy Peasy.

I forgot about the Camcorder mount...oops. There's a how-to about it in the How-To section.

*cracks knuckles...* I'll start with the cargo space. CO2 Tire Inflation System 3D Mag Light Fire Extinguisher Lots of D-ring tie-down hook 1000W Power Inverter Plywood cargo drawer (broken, removed) Plywood Bed-form (removed with the drawer, no longer needed. In garage in VA) Moving to the front... CB Radio Switch panel with switches for fog lights, driving lights, horn turn off, and electric fan Uniden BC350 Scanner Land-Meter Pitch/Roll gauge Cobra GPS500 Radar Detector Windshield mounted amber strobe light (along with a roof mounted amber rotator) 12VDC Cigarette Lighter power block 400W Power Inverter Laptop Mount (to be installed) Stereo: Alpine head unit w/ AI-Net switch box, iPod controller and Terk XM Adapter (no subscription at this point, got for free) MB Quart component speakers (front) MB Quart 2-way coaxial speakers (rear) JL Audio 12" subwoofer Alpine 4-ch amp JL Audio mono-amp I'm formerly a pro Car Audio installer, so all of this is hidden, with the exception of the subwoofer box.

I outraced a fully loaded Semi today!!! I'm so stoked!!!

Sure. But the rev limiter will knock it back down at 6250. Don't ask me how I know....I thought I was in 2nd, but I was in 1st and when to flog it through a big mud hole.....VRR-RR-RR-RR-RR-RR....it was sad.

Ohh, right, a sticker printed off their home inkjet printer, that cost them all of 3 cents to make. Still...that doesn't quite add up to $30. And then they charge you $5 to ship a teeny tiny little box. Shipping on that is like $1.05, and you can put it in a 39 cent bubble mailer and it'll be fine.

That's pretty good. I was at 160 miles and 1/2 tank when I last glanced at it.

Letters is 7 letters long. You might want to reconsider your wording.

With the drop brackets, you might have better luck than the rest of us.

I think she was being facetious as well. Word of the day...y'know.

He was being facetious.

No. That's not a Factory Service manual at all. That has access to service procedures, but is not at all affiliated with Nissan. That is an EBSCO product.

Hint: Phat G20.

What are the part numbers?