Hey y’all! Doing a little update on what’s been going on with the Pathy and some upgrades hawairish and I plan to tackle this weekend. For starters, this Pathy already fell into my hands with a -3” SFD -4.636 gear swap -R200 Lokka -H233B LSD rear diff (repacked @ 150 lb/ft torque) -airlift 1000 -3” strut spacers -2” coil spacers -Warren Manual hubs And much more in the link below http:// https://expeditionportal.com/forum/threads/2002-pathfinder-r50-overland-build.134475/ Originally this pathfinder was Duke90’s, my brother, he then later sold it to me and I’ve had the truck over the last 10 months or so. As his was, this Pathy is also my DD and within the first month I notice some pulling and vibration on the passenger side wheel which eventually became so severe I had to garage it till I could tow it out for repair. The damage from what I later understood was a crack on the subframe cross arm which attaches also to my control arm. That side of the frame was completely torn from the bolt. *I assume this was initially caused by some prior trips we did in the Pathy. Never heavily offroaded but did do 300+ miles of various overlanding terrain with no ‘missing link’. I’m assuming this initially created some sort of damage that had slowly got progressively worse. I figure it must of been a drop or rough hit because the damage needed a lot of force for such a tear to occur. I had great difficulty finding a fabrication shop willing to take on the repair. I mean not even collision centers wanted to touch it but from one referral to another I finally got in touch with tnj performance and got my Pathy back on the road again. Note: the truck sat till around the middle of August (with frequent starts to continuously run fluids). Since then I’ve been fortunate enough to be in touch with hawairish and added a aluminum mid-skid and ‘missing-link’ to the truck. I’ve taken it on my first 4x4 trip to cathedral valley/canyon lands/ spider rock/ Tucson and then Anza borrego on the SoCal xterra event and ocotillo Wells after. Have had no problems then and since the trip so all seems clear with the repair. (Put roughly 4K miles on during this time) As for the parts update This weekend [user]hawairish[/user] and I are planning to do -LR Defender 90 Rear coil springs #NRC9448 -Bilstein 5165s #25-261400 -Viair 485c OBA install Keeping the rear spacers this should bring the Pathy up to a 4” lift in the rear and the much added convenience of OBA that also future proofs the Pathy for adding air-lockers if eventually decided. I’m happy to have this truck and looking forward to all the additions we’ll go through and trips we’ll make through the years. Sent from my iPhone using Tapatalk