97Pathfinderman

Ive wondered the same thing. I have not replaced the rear springs but someone could have in the past.

I really don't mind any of that I am just looking for enough clearance to fit 32's. Yours is what i want mine to look like by the way

I'm sure your right. I'm gonna use the struts that are on there now because they are still in good shape and I don't think it will effect the height of the lift. How hard was it installing the coils? It seems to be a pretty straight forward job.

So if I can mill down my 1.5 inch spacers to 1 inch and put my 2 inch coils on it will sit like yours?

I put them on after I bought it expecting it to lift the truck 2 inches like it advertised. It lifted the rear the right amount but it barely lifted the front at all. I don't mind it being a little taller in the back but it is very noticeable right now. I have not changed my suspension in any way since I put the spacers in.

Ok I actually measured the front the way you said and it is about 2.5 to 3 inches higher in the back so i think the springs would make it look a whole lot better. If I jack it up all the way up off the ground the wheels spin relatively freely. They make a little clicking noise but it doesn't hinder with the spinning. I probably sound dumb about this but I have always dealt with straight axles and this is my first pathfinder. Do you know why there would be this much of a difference in the height of the front vs the back? I'm guessing the stock springs are just wore out.

Hey guys I have the 1.5 inch strut spacers on the front of my 97 Pathy and the 2 inch spacers on the back. It sits with a pretty noticeable rake and I want it to sit level. I purchased the 2 inch lift coils from 4x4parts.com without researching. I am hearing that the combo will not work and my cv axles will lock up. Would it be a better idea to take my spacers off and just put the springs on? I really need some advise on this because all I want is for the damn thing to sit level. I also don't want to do a sfd right now because I am in college and don't have the time to build/enough money to buy a kit. I would really appreciate your input.

I can't seem to find any. Could you tell me where to look?

Has anyone ever taken the fender flairs off a 1996-1999 r50? I want to take mine off and want to see what it would look like.

I replaced the speakers in my 97 and the rear ones don't work. Does anyone else have this problem or am I gonna have to run new wires?

The upper control arm bushings are the exact same thing as the lower. Some auto parts stores have them listed under different part numbers or may not carry them at all but I changed them on my 97 and they are the same. Thought this might be helpful because I had a time figuring it out.

Sorry bout that. Just new to the forums.

Where can I get a NPORA decal for my pathy?

Do you know where to find one and which Isuzu it comes off of?

I have recently bought a 97 r50 and I can't find a decent brush guard. Anyone know where to find one and how much will it be?