1 ton SAS

[johann_peralta]

15 hours ago, Slartibartfast said:

Sorry if I missed this earlier, what transfer case is that?

np201. I believe it came in 57-68 dodge w100/w200/w300. 

[johann_peralta]

made the mid shaft to connect the stock t-case to the np201. 

[johann_peralta]

had to drop the case to get the shaft in.. what a hassle

[johann_peralta]

heres the beginning of the passenger side mount. 3 1/2" bolts on the cradle side. Im planning on welding 2 tabs to the case and then use a pin/bolt through the tabs and the tube to make it like a "quick disconnect". Hopefully will get the other mounts knocked out soon.  

[johann_peralta]

here is the case mounted up with 2 mounts. would like to get 2 more in also. I put 3/8" rubber bushings between the mounts and the cradle walls (after pic).

[johann_peralta]

Got driveshafts made for the car

[johann_peralta]

[johann_peralta]

Rear one is a combination of a 2wd preface lift R50 DC that i took apart and clearanced, the front driveshaft of a 4x4 r50, and the slip yoke of the f350

[johann_peralta]

front one is a combination of a wj front shaft, 4x4 r50 rear shaft, rear f350 shaft

[johann_peralta]

Finished the steering up. can turn the wheel with a pinky

[johann_peralta]

[johann_peralta]

 

[johann_peralta]

Here is how I got the track bar parallel to the drag link

[johann_peralta]

top portion of another t-case mount bracket

[johann_peralta]

3/8" rubber bushing in between to hopefully minimize vibration

[johann_peralta]

How it mounts together

[johann_peralta]

[johann_peralta]

[johann_peralta]

[Slartibartfast]

Bet it's nice to have it rolling! How's it handle?

[johann_peralta]

3 hours ago, Slartibartfast said:

Bet it's nice to have it rolling! How's it handle?

Pretty well! I've been running around the neighbor hood in it frequently just listening and for anything odd. Other than clicking/clanking ball joints its been great. Sway bars help a ton!

[johann_peralta]

[johann_peralta]

The balljoints were previously shot, so we replaced them.

 

[johann_peralta]

[johann_peralta]

Made a temp track bar (made it drive so much better). Wont be making a new one until I get a tube bender.