Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Automatic to Manual swap


Mkeesucker
 Share

Recommended Posts

Anyone done this swap? I really want mine to be a 5 speed. I have seen someone on youtube say that they have done the swap but i can not find anything about it on any forums. Any direction would be great. Thanks

Link to comment
Share on other sites

I followed the Haynes manual to be honest, all the bolt holes are there including clutch pedal, lines, etc makes it really yes, but there is a couple tricks, like when you remove the trans you'll notice a bunch of wires and a switch that's controlled with a cable via your shifter, stick it in N or P (someone confirm this for me I'm not to sure since I did it the hard way) then take it off and lock it into position, I cut all the wires and then it was a nightmare to figure out the no start issue after wards. Otherwise if you have a donor and a week or two, also a homie or two doesn't hurt, should be no issue.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...