HitMan Posted March 31, 2013 Share Posted March 31, 2013 I noticed something new today that has brought some concern to my attention.... It started with vibration and shake in the wheel going 55mph while cruising/braking/accelerating/etc. it always shakes. It is speed dependent, so my first thoughts like usual are wheel out of balance or somehow lost alignment. So, I looked under the truck and grabbed the half shaft and noticed that I could move it maybe an inch back and forth in and out of the hub on both sides. I don't remember this being like this in the past? I have warn hubs installed, so naturally I put them back in 4x4 to lock them back and see if this could change anything. I drove it again that night after moving the half shafts and locking the hubs and did not notice anything again. I drove it again today and it seemed to come back, but once I made a few sharp turns it went back to normal, which leads me to think something is wrong with the half shafts. I do have the OME lift installed as well. Any ideas? I looked at my 04 which is still all stock and I was not able to move the half shafts at all in or out. Do I need to tear into my hubs again to see what might be going on? Maybe it is not locking at all anymore. Help Please! Link to comment Share on other sites More sharing options...
Hytekrednek Posted March 31, 2013 Share Posted March 31, 2013 I know that on my WD21 there is a c-clip that keeps the half shaft for doing what you are describing. Was there a clip on yours when you installed the warns??? Just a thought. James 1 Link to comment Share on other sites More sharing options...
HitMan Posted March 31, 2013 Author Share Posted March 31, 2013 I do believe there was, maybe I just need to tear into it and check. Link to comment Share on other sites More sharing options...
Hytekrednek Posted March 31, 2013 Share Posted March 31, 2013 Good luck and keep us posted. We also luv pics. James Link to comment Share on other sites More sharing options...
HitMan Posted April 6, 2013 Author Share Posted April 6, 2013 So, you were right, I opened them up and sure enough I forgot to install the clip on both sides! Yikes! All set now and everything is tightened back down so I'll take it for a spin and see if it miss behaves again. Thanks for the reply. Link to comment Share on other sites More sharing options...
Hytekrednek Posted April 6, 2013 Share Posted April 6, 2013 No problem and I'm glad I could help you out. James 1 Link to comment Share on other sites More sharing options...
pathybuilder Posted April 7, 2013 Share Posted April 7, 2013 I know that on my WD21 there is a c-clip that keeps the half shaft for doing what you are describing. Was there a clip on yours when you installed the warns??? Just a thought. James So, you were right, I opened them up and sure enough I forgot to install the clip on both sides! Yikes! All set now and everything is tightened back down so I'll take it for a spin and see if it miss behaves again. Thanks for the reply. No problem and I'm glad I could help you out. James I was thinking the exact same thing as I just installed my Warn's today. Nice diagnosis Hytekrednek. Link to comment Share on other sites More sharing options...
Hytekrednek Posted April 8, 2013 Share Posted April 8, 2013 No prob I had just read a couple of threads on the install of man hubs and that sounded like the right thing to me. James Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now