new driver power window motor and regulator..

[captandy]

Any one got experience repacing regulator and motor? got panel off etc. but i know theres always a trick!!

 

http://www.ebay.com/itm/130573705813?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

[dynomax]

I dunno, but with the key just on without engine running or on a cold day in the winter mine barely roll up! Any fix for that? All 4 are the same. They roll up good when its warm out and the trucks on ;P

[JamesRich]

ahardbody took apart and cleaned his motors and fixed the slow problem I think. He should chime in shortly. My passenger side does this but the driver is ok.

James

[captandy]

silicone spray down the channels worked like a champ for a year...

[ahardb0dy]

When I pulled the regulator on my 94 I unbolted the glass from the regulator (bottom of the glass 2 10mm bolts), lifted the glass manually and held it in place with 2 wooden wedges, unbolt the regulator track top and bottom, (per a pic of the regulator from rockauto it shows 2 bolts top and 2 bottom on the regulator track) unplug the motor plug, and you should be able to remove the regulator with the motor as an assembly. It wasn't that difficult.

 

this pic is from my 94, not sure if your 98 is different but it should be similar:

 

 

these are the 2 bolts that hold the glass to the regulator (again on my 94):

 

Edited September 12, 2012 by ahardb0dy

[captandy]

thanks ... all done