can someone with a stock height pathy take some measurements please?

[andrewt6447]

If there is someone out there with a stock height pathy (anyone?) I'd like to get the measurements fom the upper arm inner pivot (centre) to the ground, and the outer arm (the flat part where the balljoint bolts on) to the ground. At the center point of the bj please. Approximate (within a couple of mm) will be fine. I'm after the stock angle of the upper arm at ride height for some new upper arms as the calmini one's are $800 odd here, and I can build my own. I have all the other measurements I need, just need this one to work out the extra length to make up for the camber change. Mine is way off stock height so it's no good measuring that.....

Or does someone know this already?

Cheers.

Edited May 18, 2012 by andrewt6447

[Danger]

If no one else does I can measure it out tomorrow. Im just on my way to work now.

And it is stock UCA's.

[Trogdor636]

This isnt the exact answer to your question, but this will set you at factory ride height so you can measure.

 

http://www.nissanpathfinders.net/forum/index.php?/topic/25794-ride-height/

[andrewt6447]

This isnt the exact answer to your question, but this will set you at factory ride height so you can measure.

 

http://www.nissanpat...94-ride-height/

Cheers, yeh, I read that.....but it's a lot of adjusting....I will if I have to. Hopefully Danger can measure his

edit; Actually, duh, I can work it out from this. Cheers for making me think about it....

Edited May 19, 2012 by andrewt6447