4doordrift Posted April 2, 2012 Share Posted April 2, 2012 Why does my steering feel so damn loose and floaty? anyone have this issue and fixed it? Link to comment Share on other sites More sharing options...
Daddy Rim Posted April 2, 2012 Share Posted April 2, 2012 My '01 experienced the same "floaty" feel, which required an adjustment of the steering box preload. The FSM has instructions on how to make this adjustment. Oddly only my '01 required this adjustment and not my 97 that had amost double the mileage. If all of your steering components, i.e. steering rack bushings, tie rod ends etc are in good condition, this may be something to look at. J. Link to comment Share on other sites More sharing options...
ltsnotme Posted April 2, 2012 Share Posted April 2, 2012 Also check your steering gear mounting insulators. One of them is located directly under the oil filter, and after prolonged exposure to oil (during filter replacement), it deteriorates and the whole gear assembly starts moving laterally. Link to comment Share on other sites More sharing options...
devonianwalk Posted April 2, 2012 Share Posted April 2, 2012 To change the isolator the rack has to be removed from the chassis. Can this be done with out raising the front wheels off of the ground? Im going to have to replace my rack this summer. :thumbdown: Link to comment Share on other sites More sharing options...
ltsnotme Posted April 2, 2012 Share Posted April 2, 2012 (edited) To change the isolator the rack has to be removed from the chassis. Can this be done with out raising the front wheels off of the ground? Im going to have to replace my rack this summer. :thumbdown: You don't need to remove the rack to change the insulators. Just remove the two mounting brackets, and you can get them out. I raised my front when I changed mine, but I don't see why you would necessarily have to, as long as you have enough room under there to get the brackets off. Also, I don't remember if that's how I did it, but the brackets should probably be removed one at a time so the gear assembly doesn't move off center. Below are tightening specs (for my '96). Edited April 2, 2012 by ltsnotme Link to comment Share on other sites More sharing options...
4doordrift Posted April 3, 2012 Author Share Posted April 3, 2012 hmm good info, definetly something to look at. Giving my pathy a small make over this summer, Ac Lift, strut spacers, 32's, new release bearing, new upgraded clutch, load warrior roofbasket, new brakes all around, new fluids everywhere and fix my damn floaty steering. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now