Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Shortening auto shifter

Guest SuperSon

By Guest SuperSon,
in The Garage

 Share

Recommended Posts

Guest SuperSon

Guest SuperSon

Posted
Posted

Morning all!

Has anyone tried to shorten a shifter on auto tranny. Im not sure but I think ive seen on my manual before that the tranny is being shifted thru cable.

 

Im going to do a body lift also and will it raise up the console on the shifter?

Link to comment
Share on other sites
GrimGreg NPORA Old-Timer

GrimGreg

Posted
Posted (edited)

Since it is cable, the BL has no effect on the shifter height.

 

As for shortening it, it probably wouldn't bee too hard, just have to be carefull of the wiring. I would assume just pull the handle part off, remove the square shaft cover and cut the shaft, then cut the suare cover to match and reassemble. probably have to shorten the lock rod also. (The cable attaches under the selector area, so it wouldn't even be part of the equation.)

Edited by GrimGreg
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...