my buddy is telling me that the caliper blew on my 93 pathfinder. Is there a site which guides me through changing this out? Also, if I need new Rotors am I going to need to take off the whole 4WD mechanism?
Old thread, but looking for help. I think I am having the same problem. I have tried the interlock switch and I am getting nothing.
<<Frustrated as hell.
How does one go about doing this mod? I am having a similar problem. I get the click.
I put in a new starter on Saturday.
Today I went home on lunch and lo and behold it wouldn't start.
Needless to say I am a little bit frustrated.
Any help is GREATLY appreciated!
I did a search and found over 1000 posts on starters.
Here is the story and what is going on.
I was able to start the Pathy when I would pump the clutch for awhile. After that nothing.
Battery Good/Alternator good.
When I turn the key I get 1 click.
On Saturday I replaced the Starter and it fired right up. Today I went home @ lunch and I am having the same problem. 1 click and then nothing.
The Starter I put in was remanufactured.
Any thoughts?
Clutch switch? If so how do I verify?
Bad Starter? PITA!!
Here is the story and what is going on.
I was able to start the Pathy when I would pump the clutch for awhile. After that nothing.
Battery Good/Alternator good.
When I turn the key I get 1 click.
On Saturday I replaced the Starter and it fired right up. Today I went home @ lunch and I am having the same problem. 1 click and then nothing.
The Starter I put in was remanufactured. Bought it from Autozone.
Any thoughts?
Clutch switch? If so how do I verify?
Bad Starter? PITA!!