Hope I'm not being a pest with all these questions...Im about 20 years late to the Pathy party! LOL
So, now that I have working power door locks, I thought I would attempt to get the keyless/alarm working.
Currently the red led on the switch (center console) constantly flashes (fast) regardless of which position it is in. I normally just leave it off.
I ordered a key fob from eBay, it says Pathfinder on the fob and the seller said it was for my year.
Got the fob, found the programming instructions and the TSB (thank you to the poster).
My hood switch was broke, so I got a new one from a local stereo/alarm shop and it fits perfect.
When I cycle the ignition, and then hold down the program button on the module (under seat), I get 4/5 quick muted "clicks". I assume its form the alarm horn?
then the module beeps in 1 second intervals and will not accept the key fob signal.
It keeps that pattern for a minute or 2, or until I cycle ignition.
I never get the horn blast.
I did get the impact sensor to trigger the alarm a few days ago, so I know the siren works.
I also found another programming sequence I found, very similar in steps (never cycle ignition) that caused the same 4/5 "clicks" but then the module would beep slower, 3 sec intervals? If I then pressed the key fob button the module would react to the button press. No confirmation beep though, and never programs. I think this proves the fob is at least working???
Any one have any advice or tips? You have all been awesome so far!
Thanks in advance...again.