Cygnusia

Well, it's kind of a mute point now, as my Pathfinder is no more. :sniff: Some lady decided to pull out into the middle of traffic on Saturday and I plowed straight into her. The Pathy was totalled... but you should have seen the Lumina I hit. Looked like a wrecking ball slammed into it, and knocked it on its side. That Pathfinder was a tank! On a good note, everyone walked away from the accident. On a BAD note, she didn't have any insurance, and my insurance pretty much fleeced me so I'm back to square one.

Thanks for the reply! I have tried it when the light is flashing but the alarm goes off anyway! After that I either have to disconnect the battery or just wait it out... My keyfob didn't come with the Pathfinder, but it's a factory original and should work. My question is, (and probably a stupid one, I know...) can you reprogram with the alarm switch set to the off position? :help:

Hi there, I'm new to the site and looking for an answer that's been niggling me for quite some time... Pardon me if this is a stupid question, but do you have to have the console switch turned on when you're programming a remote? I'm a bit gunshy, because every time I've tried to turn it off manually (without a keyfob) it goes off and I have to deal with trying to get the blasted thing to turn off and dealing with the alarm sounding for several minutes. Also, can you leave the alarm console switch on at all times? Obviously, I've had no luck getting my new keyfob to program.... can anyone answer this question?