Leaderboard

Today had enough progress that it deserved its own comment. After spending a couple weeks designing a few ideas that gave me some adjustability, decided the other day to just get on with it and make a static mount in what I seemed like the right spot. Pretty straight-forward at this point. This is the first mock-up with a tire...finally! There's so much space in there, that it makes the 2.0 coilovers seem puny. But hey, no more farting around with the stupid coil bucket on the McPherson strut! There's about 4" of space between the springs and tires, and about 2-3" from the inner fender. The first two pics in this post show a different attachment method, but this will be the end result. There will be a strut 'ring' atop the strut tower with bolts welded in, then the coilover mount attaches from underneath. This way I won't need to remove all the crap above the strut towers to change anything. After getting the mounts all welded up, I decided to see if the spring selection was the right one. So, time to see if it can support itself! Ride height compression... And so, I have coilover mounts! Right now this is about 1.5" taller than I predicted. I'll eventually put a bumper and winch on to pull things down another 0.75" or so and hopefully they'll settle the rest. I can't lower it any more unless I change springs, so I'm going to see how this does. Overall, I'm satisfied. I'll eventually make some changes to the rear suspension to level things out better, but I think I'll have some squat for a while. Painted the steering links today, too. Panhard and radius arms refreshed with bushings and paint the other week. In this pic, the axle is supporting the truck, so I must be doing something right! The axle is at ride height so I have some pretty good clearance.