Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Camber bolts help

BamaQX402

By BamaQX402,
in How-To's

 Share

Recommended Posts

BamaQX402 NPORA Veteran

BamaQX402

Posted
Posted (edited)

I'm waiting for front axle bearings/seals to finish my front end. I've installed KYBs, OME HD springs, & 1" SF spacers.

I orderd a set of camber bolts from Rockauto, then a 2nd set. But I ended up with 2 different types. 1st set is a bolt, nut, & washer with tab. How do I use that washer?

2nd set is even more complicated; bolt, plastic egocentric sleeve, 3 flat washers, hex washer with raised egocentric boss, & nut.

Any help and advice would be greatly appreciated.

Planning on one of each on both sides. Which would be best for top/bottom?

Should I just put in stock bolts and trust the guy doing the alignment to know how to use them?

I took a pic, but system says I have 0 mb of space to load??

 

Edited by BamaQX402
spelling
Link to comment
Share on other sites
Guest

Guest

Posted
Posted
I'm waiting for front axle bearings/seals to finish my front end. I've installed KYBs, OME HD springs, & 1" SF spacers.
I orderd a set of camber bolts from Rockauto, then a 2nd set. But I ended up with 2 different types. 1st set is a bolt, nut, & washer with tab. How do I use that washer?
2nd set is even more complicated; bolt, plastic egocentric sleeve, 3 flat washers, hex washer with raised egocentric boss, & nut.
Any help and advice would be greatly appreciated.
Planning on one of each on both sides. Which would be best for top/bottom?
Should I just put in stock bolts and trust the guy doing the alignment to know how to use them?
I took a pic, but system says I have 0 mb of space to load??
 

Both sets should be like the first you received. If using two sets, the washer tabs in upper hole should face engine. For the bottom, the tabs face the wheel.


Sent from my Pathfinder
Link to comment
Share on other sites
Guest

Guest

Posted
Posted
Great! now please excuse my ignorance, but do I want the washers towards the front or back?

You should have two washers per bolt. If you only have one, I’d put it on the side of the bolt head

 

 

Sent from my Pathfinder

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...