Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

2006 Pathfinder LE, Low oil Pressure at Idle


sscott1318993
 Share

Recommended Posts

So basically I purchased this vehicle with 122,000 miles (now has 128,000) and notice the pressure gauge was maxed out (sending unit had gone bad), so I replaced it myself and everything was fine. About 2 weeks ago I changed the oil myself (pennzoil platinum, with a purolator filter). A few days later I was at a stop light and my oil pressure gauge needle caught my eye, it was bouncing up and down, but continued to inch down, but not to the point where it would set off anything on the instrument gauge. Light turned green, needle goes back to the half way point and stays consistent until next red light and same thing. Next day I paid attention more and noticed this only happens after driving for a period of time allowing the oil to heat up. I called my friend down at the local Nissan shop and said replace filter with OEM and start there. Changed it out 2 days ago and still the same. Anyone know anything about this issue or how to fix?? Thanks

Link to comment
Share on other sites

What weight of oil did you use? No oil leaks?

 

I've noticed on my pickup that I have lower oil pressure with synthetic, I swapped it out for the same weight of synthetic blend and the oil pressure stays at 30-45 psi while running.

 

You might try changing to a high mileage oil, either Castrol or Valvoline. They're both syn blends. The molecules of synthetic are smaller than a conventional oil, so the oil tends to get squeezed out the sides of worn bearings.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...